In many cases, we don’t think about the garage or pay much attention to its appearance. They’re just a place to park your car and store extra boxes of Christmas decorations and more. However, like any other room in the house, the garage floor must be maintained. Due to its use, it can spill water in combination with water, gas and oil, so the garage floor is easily damaged and, after years of use, it can start to fall off. Epoxy coating is a solution to the garage floor problem. The epoxy coating helps prevent staining, moisture problems, and maintaining appearance by applying a coat of sealer and protective agent to the concrete garage floor.
Epoxy flooring installation requires preliminary preparation before beginning. The most important step in this process is to make sure there is no moisture, residual paint on the floor where the epoxy coating will be applied, and no cement sealer or other finish.
To test for moisture, use masking tape to place the plastic sheet in an area of 3 feet by 3 feet. Store for about 2 days, then remove and check for moisture build-up on the plastic side toward the floor. Epoxy floor coverings are not suitable in the presence of moisture. This is because epoxy needs a dry surface to properly adhere to the floor.
Then we test to see if the sealant has already been applied to the floor. This test also verifies the presence of oil in the cement. Take a cup of water and pour it directly onto the existing floor. It should be soaked on the floor at a reasonable time. If it’s a bead or sits on the floor, the floor may already be sealed or contain oil contaminants. Epoxy floors are not suitable for cement floors with any type of oil residue that is already sealed or not glued.
Finally, if you want to test a suitable garage floor to install epoxy flooring for several months, you can paint a small area with regular greasy enamel. If this test area lasts for several months, the epoxy coating can also last. However, if you decide to continue with the epoxy coating, you must remove this epoxy enamel spray paint coating that requires sanding.
Applying epoxy enamel spray paint is generally easier because there are only two-step processes than using products like epoxy floor coatings. The first and most important part of the project is to make sure that the concrete floor surface is completely clean. If there are loose chips in the cracks, remove them and close the spaces with your hands. You can use a pressure washer or steam cleaner to remove dirt and grime. Rubbing the floor with detergent will make your job a lot easier.
If the floor may have been contaminated with oil or other petroleum products, you should use a good degreasing agent to remove all the rest. If this is not removed, the paint does not stick and you are not satisfied with the result. Check this website to find out more details.